Unscrew the cover.

Loose the cover from basket.

Clean the air gap
around the magnet.

Replace the new recone
basket onto the cover.

Turn the woofer, and then
fit the cover with the basket.

 

 

Put the screws into the hole.

Tighten the screws.

Test the woofer.

Remove the solder lead the jointed between the tinsels and terminals.

Remove the gasket surrounded the cone paper.

Tear the cone paper surround and then remove the cone paper from the speaker.

Tear the spider surround
and then remove the
spider from the speaker.

Clean the magnet air gap.

Use a tape to cover the air gap
in order to prevent the dust
to go inside the air gap.

Clean the chassis starting from the surround that will fit the surround of cone paper onto.

Then, remove the dust spider
on the chassis until leaving
only the chassis.

 

Distribute the glue (normally supplied along with the
P.Audio recone-kit set) onto the surround that will
fit cone paper and spider onto the basket.

Remove the tape that previously placed on the air gap and replace the
new recone kit onto the chassis. Make it center by using the same thickness
of plastic sheet inserted around the gap.

Distribute glue onto the surround of cone paper and then placing the
new set gasket lining up to with the chassis holes.

Distribute glue onto dust cap.

Leave the glue under the
dust cap to dry.

Turn the chassis down and
let the glue dry.